Products  
   
  Pneumatic Rotary Actuator | Ball Valve With Actuator | Three Way Ball Valve With Actuator | Ball Valve Hand Lever Operated
PTFE Seat Butterfly Valve With Actuator | Pneumatic Two Way Control Valve | Pneumatic Three Way Control Valve | Y Type Control Valve
Wafer Type Centric Disc Butterfly Valve | Safety Valve Screwed End | Spool Type Solenoid Valve |
Solenoid Valve
Rubber Seat Butterfly Valve With Actuator | Pneumatic Cylinder | Flow Control Valves | Wafer Type Non Return Valve
 
     
  Back to Products  
 
Solenoid Valve  
 
     
 
Nishaka pneumatics is manufacturing Direct Acting Solenoid Valves such as 2 Port and 3 Port and it’s operation is either normally Closed nor Normally Opened .A pneumatic solenoid valve is a switch for routing air to any pneumatic device, usually an actuator, allowing a relatively small signal to control a large device. It is also the interface between electronic controllers and pneumatic systems.
 
     
 

 
Type Direct Acting Solenoid Valves
2 Port and 3 Port Normally Closed/Normally Open.
Manufacturing Range Sizes 1/8” BSP / ¼” BSP/ ½” BSP
Orifice 1.5mm Standard (Other sizes on request.)
Pressure 0 to 12 Kg/cm2
Media Air, Water & Non Corrosive Liquids & Gases
Body Hard Anodized Aluminium Body, Brass & stainless steel Against Specific Orders
Manual Overdrive Optional
Data Epoxy Molded, Water Proof, Continuous Duty Coils, 6 to 230 V AC & 9.5 Watts
Low Watts as per request
Type Direct Acting Solenoid Valves (Namur Mounting)
2 Port and 3 Port Normally Closed/Normally Open.
Manufacturing Range Sizes 1/8” BSP / ¼” BSP/ ½” BSP
Orifice 1.5mm Standard (Other sizes on request.)
Pressure 0 to 12 Kg/cm2
Media Air, Water & Non Corrosive Liquids & Gases
Body Anodized Aluminium Body, Brass & stainless steel Against Specific Orders
Manual Overdrive Optional
Data Epoxy Molded, Water Proof, Continuous Duty Coils, 6 to 230 V AC & 9.5 Watts
Low Watts as per request.
Type Poppet Type Solenoid Valves (Namur Mounting)
3 Port and 4 Port Normally Closed/Normally Open.
Manufacturing Range Sizes ¼” BSP/ ½” BSP
Orifice 1.5mm Standard (Other sizes on request.)
Pressure 0 to 12 Kg/cm2
Media Air, Water & Non Corrosive Liquids & Gases
Body Hard Anodized Aluminium Body
Brass & stainless steel Against Specific Orders
Manual Overdrive Optional
Data Epoxy Molded, Water Proof, Continuous Duty Coils, 6 to 230 V AC & 9.5 Watts
Low Watts as per request.
 
  Top  
 
 
Home | About Us | Products | Gallery | Enquiry | Contact Us
© 2012 Nishaka Pneumatics. All Rights Reserved.